Visualize Music with a Muscled FPGA

Picture of LED Music Visualizer with Zybo Board

The Zybo Board is one of the most powerful tools in FPGA and this is because it is FPGA combined with an ARM processor that widens the spectrum of possibilities with FPGA. Today’s post is yet another dive into Zybo’s possibilities and in this project a visualization of audio signals or music will be accomplished. The author has been very detailed about this project and has explained every aspect of it in 18 steps.

The Hardware needed for carrying out this project are the Zybo Zynq 7000 FPGA board, a neo pixel LED matrix, a 5V 10 A power supply, a female DC power adapter, 3 pin male to male header, a 1mF capacitor, an audio splitter and some jumper wires. The connection diagram is provided by the author in step 17.

The code basically uses the principle of FFTs to detect frequency components in the audio file. Depending upon the magnitude of frequencies received, the LED display has been programmed to light up. 16 steps starting from opening Vivado to run the code to generating a bit file for the FPGA has been provided by the author. You can download a zip file which contains all modules relevant to the project. The author has used a combination of C, custom Verilog and HDL to code the project. This gives an ease in defining GPIO ports and makes the circuit a lot simpler.

Another interesting aspect is that the FPGA has been so coded that with the help of switches, your LED matrix can either act as a spectrogram or as a visualizer seen in media players.

Let me challenge you to achieve similar results adapting your own FPGA!

By jtdykstra

Tags: , , , , , , , , , , , , ,

Leave a Reply

You must be logged in to post a comment.